Search service manual

General Guidance An isolation Transformer should always be used during the servicing of a receiver whose chassis is not isolated from the AC power line.

Use a transformer of adequate power rating as this protects the technician from accidents resulting in personal injury from electrical shocks. It will also protect the receiver and it's components from being damaged by accidental shorts of the circuitry that may be inadvertently introduced during the service operation.

Technical Specifications 2004 Audi A4 1.8T Sedan ENGINE: Type Inline 4-cylinder with exhaust gas turbocharger and charge-air intercooling, DOHC Arrangement Front mounted, longitudinal Bore 3.18 in. 81 mm Stroke 3.40 in. 6-speed manual transmission for quattro. With 6-Speed manual transmission FS: 2004 Audi -Oil changed every 5,000 miles with synthetic (one time I went to 7000 miles. We are doing an automatic transmission fluid change on a 2004 Audi A4 with the 1.8t engine. Get the best deals on Manual Transmission Parts for 2004 Audi A4 Quattro when you shop the largest online selection at eBay.com. Free shipping on many. For 1996-2005 Audi A4 Quattro Manual Trans Speed Sensor 64524NJ 2003 2001 2004. Brand: Beck/Arnley. For 1996-2005 Audi A4 Quattro Manual Trans Fluid Febi 72887RG 1997 1998 1999.

If any fuse (or Fusible Resistor) in this TV receiver is blown, replace it with the specified.

When replacing a high wattage resistor (Oxide Metal Film Resistor, over 1W), keep the resistor 10mm away from PCB.

Keep wires away from high voltage or high temperature parts.

General Servicing Precautions
1. Always unplug the receiver AC power cord from the AC power
source before;
a. Removing or reinstalling any component, circuit board
module or any other receiver assembly.
b. Disconnecting or reconnecting any receiver electrical plug or
other electrical connection.
c. Connecting a test substitute in parallel with an electrolytic
capacitor in the receiver.
CAUTION: A wrong part substitution or incorrect polarity
installation of electrolytic capacitors may result in an
explosion hazard.

2. Test high voltage only by measuring it with an appropriate high
voltage meter or other voltage measuring device (DVM,
FETVOM, etc) equipped with a suitable high voltage probe.
Do not test high voltage by 'drawing an arc'.

3. Do not spray chemicals on or near this receiver or any of its
assemblies.

4. Unless specified otherwise in this service manual, clean
electrical contacts only by applying the following mixture to the
contacts with a pipe cleaner, cotton-tipped stick or comparable
non-abrasive applicator; 10% (by volume) Acetone and 90% (by
volume) isopropyl alcohol (90%-99% strength)
CAUTION: This is a flammable mixture.
Unless specified otherwise in this service manual, lubrication of
contacts in not required.

5. Do not defeat any plug/socket B+ voltage interlocks with which
receivers covered by this service manual might be equipped.

6. Do not apply AC power to this instrument and/or any of its
electrical assemblies unless all solid-state device heat sinks are
correctly installed.

7. Always connect the test receiver ground lead to the receiver
chassis ground before connecting the test receiver positive
lead.
Always remove the test receiver ground lead last.

8. Use with this receiver only the test fixtures specified in this
service manual.
CAUTION: Do not connect the test fixture ground strap to any
heat sink in this receiver.

• anritsu 360b vna operation manual[5 MB]
• anritsu mh680b tracking generator manual[1 MB]
• anritsu ml422b c selective level meter maintenance manual[32 MB]
• anritsu ml422b c selective level meter operating manual[47 MB]
• anritsu ms610a spectrum analyzer operation manual[7 MB]
• anritsu ms610b b j j1 opt 01 opt 02 spectrum analyzer operation manual[21 MB]
• anritsu ms610b j j1 spectrum analyzer service manual[60 MB]
• anritsu ms710a c d e f spectrum analyzer operation and service manual[125 MB]

• anritsu ms2601a j spectrum analyzer operating manual[7 MB]
• anritsu ms2601a j spectrum analyzer service manual[4 MB]
• anritsu ms4661 ms4662 network analyzer spec sheet[205 KB]
• anritsu ms4662a network analyzer operating manual vol 1[5 MB]
• anritsu ms4662a network analyzer operating manual vol 2[2 MB]
• anritsu wiltron 560 7n50 rf detector schematic[250 KB]
• anritsu wiltron 560 5400 series rf detector operation maintenance manual[142 KB]
• anritsu wiltron connector cable[426 KB]